Valve Exhaust flap control (RX1) made for Alfa Romeo Giulia GTAm [952]

Valve Exhaust flap control (RX1) made for Alfa Romeo Giulia GTAm [952]

Product number: A-001-029

€279.00*

Prices incl. VAT plus shipping costs to Germany

Choose your model

Control via remote control

Plug & Play install

at the switch valve under the trunk floor

The module is suitable for racing vehicles that are built on a Alfa Romeo Giulia GTAm [952]. Not approved for use on public roads according to the German Road Traffic Regulations (StVO). For racing, show purposes, or export only.

Product information "Valve Exhaust flap control (RX1) made for Alfa Romeo Giulia GTAm [952]"

With our flap control for your Alfa Romeo Giulia GTAm [952], you have the ability to manually control the exhaust flaps. The control is done using a remote control. This gives you full control over your vehicle's sound on the race track!

Functionality and Benefits

Sport ModeThe exhaust flaps are opened, increasing the volume. The result is a sporty sound.Standard ModeThe factory control is restored.Comfort ModeThe exhaust flaps are closed, reducing the volume.

Control independent of driving profile

You decide on the vehicle sound, not the selected driving profile

Proper standard mode

When the module is deactivated, everything acts as if no module is installed

Freely programmable start mode

You decide on the sound when starting the vehicle

No intervention in the CAN bus

No risk to other control units

No influence of software updates on the control

Plug & Play with original connectors

No damage to the original cables, no use of wire taps

Can be reverted at any time without any traces

Remote control

High quality with brushed stainless steel front

High range

Developed for the racetrack in Germany

Our products are specifically developed for your vehicle to enable more driving pleasure on the racetrack and to comply with track-wide decibel limits.

Installation

The installation is done plug and play at the switch valve under the trunk floor. The cables are designed to be of adequate length.

Start Mode

The start mode describes in which mode the device should start after the ignition is turned on. In the standard configuration, the device saves the last set mode (Last State).

The start mode can be freely programmed as desired:

Last State: Press the button for "Sport Mode" 5 times within 5 seconds.
Other Modes: Press the button for the mode you want to set as the start mode for about 10 seconds.

The flaps open and close 5 times to confirm the successful programming of the start mode.

Notes

No approval in the StVO (German Road Traffic Regulations)
For use in motorsport or for show purposes only
The flaps should not be completely closed during full load driving
Installation at your own risk
No liability is assumed for any damages resulting from disregarding the notes